15
have entered a valid 6-8 digit code, you have to wait 30 minutes before
you can open the safe door. After 30 minutes, you will have 5 minutes to
open the safe door. If you wait longer than 5 minutes, you have to start
the process again.
• Press the [ON] key
• Press key [6] followed by the [#] key
• Enter the 6-8 digit master code followed by the [#] key
• Now enter the desired time delay and open window length, i.e. for a
30 minute time delay and 5 minute open window, enter 305
For a 5 minute time delay and 5 minute open window enter 055
Deleting the time delay and open window
• Press the [ON] key
• Press the [#] key
• Press key [6] followed by the [#] key
• Enter the 6-8 digit master code followed by the [#] key
• Enter [0][0][0]. The time delay is now deleted
Opening the safe with time delay and open window
• Press the [ON] key
• Enter a valid 6-8 digit code
• The time delay has started. A red LED flash and acoustic signal will
happen every 5 seconds
• When the time delay is over the open window will begin. During the
open window, a green LED will flash with an acoustic signal every 5
seconds
• During the open window, re-enter a valid 6-8 digit code and push the
button to release the lock
• Open the drawer within 5 seconds
Current supply / battery change
Low power is shown by the red LED flashing and a quintuple acoustic
signal. The battery cover is located at the bottom of the lock. Remove
the battery cover and carefully take out the battery. Unclip the wire and
replace the battery. Take care when changing batteries to ensure that no
cables are damaged.
NOTE: You can not change your code while the lock has low power. However you can
still open the lock
