• Press and hold key [9] until the lock beeps twice
• Enter the 6-digit master code
• Now enter the desired time delay and open window length, i.e. for a
30 minute time delay and 10 minute open window, enter: 3010
• The lock will beep twice
• Enter the time delay and open window again to confirm. The lock will
beep twice. The time delay and open window are now set
How to open the safe with the time delay active
• Enter a valid 6-digit code. If the code is entered correctly, the lock will
beep twice
• When the time delay begins, the LED will flash every 2 seconds
• Once the time delay ends the open window will begin. During the open
window, the lock will beep once every 2 seconds
• During this time, turn the handle to the open position and open the
safe door
How to change / remove the time delay active
• Enter a valid 6-digit code, if the code is entered correctly the lock will
beep twice
• When the time delay begins the LED will flash every 2 seconds
• Once the time delay ends the open window will begin
• During the open window, follow the steps of programming the time
delay to change time length
• To remove the time delay, you need to enter 0001 as the time delay
and open window length
Current supply / battery change
A series of beeps indicates that the battery is weak and must be replaced.
Only use a 9V ALKALINE battery. (Burton Safes recommend the
Duracell brand).
The batteries are located in the bottom of the lock. Remove the battery
cover and carefully take out the battery. Unclip the wire and replace the
battery. Take care when changing batteries to ensure that no cables are
damaged.
