Burstner Trecento 2011, Owner'S Manual

Page: 153 / 208

153
Belcanto/Trecento - 10/11 - Ausgabe 07/10 - 1976844 - BUE-0042-06EN
Maintenance
12
12.3.4 WS 3000 D
Checking the stabilising
device (on the side of the
friction pads)
Prerequisite: Connection to WS 3000, ball diameter 50 mm

Activate the stabilising mechanism. To do this, press the coupling handle
downwards (Fig. 193,2) from the closed position (Fig. 193,1) to its stop
limit.
A wear indicator (Fig. 194) with a bar diagram (Fig. 194,1) is attached on the
coupling handle.

When the pin (Fig. 194,2) is in the longitudinal hole at the marking with the
"+", the friction pads are still in good condition.

When the pin is at both centre markings, the friction pads are slightly worn.

When the pin is at the marking with the "–", the friction pads are worn and
must be replaced.
12.4 Hitching device Easy-Pull
Check the belt of the hitching device on a regular basis. If you discover any
cracks, abraded areas or ruptured fibres on the belt, replace it immediately.
12.5 Braking system
Have maintenance work on the braking system carried out by a specialist
workshop.
Look up the following table for the inspection deadlines.

Resetting the friction pads is not required.
Fig. 193 Stabilising handle Fig. 194 Wear indicator

It is not possible to reset the friction pads.
Model First inspection Braking system Brake lining
BPW
chassis – Every 2,000 or
3,000 km or every
12 months Every 5,000 km or
every 12 months
AL-KO
chassis After 1,500 km or
after 6 months Every 10,000 or
15,000 km or every
12 months Every 5,000 km or
every 12 months