Burstner Ixeo Time IT 590, Instruction Manual

Page: 103 / 274

103
T-Modell - 17/18 - Ausgabe 09/17 - 2891569 - BUE-0029-19EN
Living
6
6.15.1 Conversion of semi-dinette into guest bed
„
Rotate the driver's seat towards the table.
„
Push driver's seat fully forward (away from the table).
„
Convert the suspension table into a bed foundation (see section 6.13).
„
Remove the back cushion of the bench and lay it aside.
„
Place the rectangular additional cushion on the table (in front of the seat
cushion of the bench, see Fig. 137). When doing so, the cutout in the addi-
tional cushion is located on the frontal supporting wall.
„
Push the driver's seat towards the table until a closed lying surface is cre-
ated.
728
L-SG L-seating group with
lateral seat Lift-off table Transverse
bed 6.15.3
734
dinette Individual bench with
lateral seat Suspension table Transverse
bed 6.15.2
734
L-SG L-seating group with
lateral seat Lift-off table Transverse
bed 6.15.3
744
dinette Individual bench with
lateral seat Suspension table Transverse
bed 6.15.7
744
L-SG L-seating group with
lateral seat Lift-off table Transverse
bed 6.15.3
745
dinette Individual bench with
lateral seat Suspension table Transverse
bed 6.15.7
745
L-SG L-seating group with
lateral seat Lift-off table Transverse
bed 6.15.3
Z
The following representations are partly valid for different vehicles. There-
fore, the length, width and form of individual cushions may differ from the
ones shown here.
Fig. 136 Prior to conversion Fig. 137 After conversion
Model Seating group Table type Bed Section