Burstner Ixeo Time IT 590, Instruction Manual

Page: 157 / 274

157
T-Modell - 17/18 - Ausgabe 09/17 - 2891569 - BUE-0029-19EN
Appliances
9
Alde heat exchanger
(special equipment)
The heat exchanger can be used to heat the living area of the vehicle during
travel without operating the hot-water heater in the living area.
The heat exchanger is connected to the vehicle engine's cooling circuit and
thus has the same function as the vehicle heater.
Heat output is set with the living area's heating regulator.
The heat exchanger stopcock is located directly on the exchanger.
Turning on the vehicle
heating by heat exchanger:
„
Make sure the heat exchanger stopcock is open.
„
Press the " " button (Fig. 194,3) on the operating unit (Fig. 194). The
Start screen appears in the display. That turns on the heating control
system and makes the circulating pump run.
„
Press "MENU" button (Fig. 194,2).
„
Turn off gas operation or 230 V electrical operation (if turned on).
„
Set the desired room temperature. To do that, press the "+" or "-" button
next to the " " symbol.
Turning off the vehicle
heating by heat exchanger:
„
Press the " " button (Fig. 194,3) on the operating unit (Fig. 194).
Turning on:
„
Set stopcock handle (Fig. 199,1) parallel to the pipe.
Turning off:
„
Set stopcock handle (Fig. 199,1) at a right angle to the pipe.
Position The heat exchanger is installed in the rear bench seat of the central seating
group.
Alde auxiliary circulating
pump (special equipment)
Z
The heat exchanger only works when the vehicle engine is running.
Z
If the heat exchanger is not being used (as in the summer), the heat
exchanger on the stopcock should be shut off.
Fig. 199 Alde heat exchanger
Z
The auxiliary circulating pump works only if the heat exchanger has been
installed and started, and the hot-water heater is running.