Burstner Ixeo Time IT 590, Instruction Manual

Page: 104 / 274

104
T-Modell - 17/18 - Ausgabe 09/17 - 2891569 - BUE-0029-19EN
Living
6
6.15.2 Conversion semi-dinette into transverse bed (with
additional cushion table)
„
Convert the suspension table into a bed foundation (see section 6.13).
„
Remove the back cushion of the bench and lay it aside.
„
Push the cover of the lateral seat/lateral bench towards the centre of the
vehicle as far as it will go.
„
Place the bed widening onto the cover of the lateral seat/lateral bench and
the table and secure it with elastic buffers.
„
Place the rectangular additional cushion on the table (in front of the seat
cushion of the bench). When doing so, the cutout in the additional cushion
is located on the frontal supporting wall.
„
Place the back cushion of the lateral seat/lateral bench on the table
(between the seat cushion of the lateral seat/lateral bench and the addi-
tional cushion, see Fig. 139).
„
Fully unfold the support underneath the additional cushion with reinforce-
ment plate.
„
Hook the hooks on the additional cushion with reinforcement plate into the
holders on the bench seat and place the support on the floor.
6.15.3 Conversion L-seating group into transverse bed (with
additional cushion table)
„
Convert the lift-off table to a bed foundation (see section 6.13).
„
Lay aside the back cushions of the benches.
„
Push the cover of the lateral seat/lateral bench towards the centre of the
vehicle as far as it will go.
„
Place the bed widening onto the cover of the lateral seat/lateral bench and
the table and secure it with elastic buffers.
Fig. 138 Prior to conversion Fig. 139 After conversion
Fig. 140 Prior to conversion Fig. 141 After conversion