burster Italia s.r.l. ·
·
·
· Sede legale ed operativa ·
·
·
· Via Cesare Battisti, 16/18 · 24035 Curno (BG) · Tel. +39 035 618120 · Fax +39 035 618250
e-mail: [email protected] · http://www.burster.it
C.F. e P.IVA 11048400151 · Capitale sociale Euro 49.920,00 ···· R.E.A. di Bergamo 276749
Apparecchi di misura di precisione. Sensori e Sistemi
per grandezze elettriche, termiche e meccaniche
1.6
Warning Notes
Attention must be paid to the accident prevention regulations of the trade associations.
Coverings and casings are necessary before operating the sensor. This is also valid for commissioning,
maintenance and trouble shooting.
Duties of the coverings and casings are:
⇒
Protection from detaching parts
⇒
Protection from contusion and shear
⇒
Prevention from reaching rotating parts
⇒
Prevention from being tangled up and/or getting caught by parts
Coverings may
⇒
Not grind
⇒
Not rotate
Coverings are also necessary outside of operating and motion travel areas of persons. These demands
can be modified if other sufficient safety devices are available. During operation, the safety precautions
must be operative. By vibrations, damages can occur at hand-guided devices which can lead to injuries.
2
Term Definitions
2.1
Terms
Measuring Side:
Mechanical connection of the torque sensor in which the torque to be measured is applied. Usually this side has the
smallest moment of inertia.
Drive Side:
Mechanical connection of the torque sensor on the opposite side of the measuring side, usually with the largest moment of
inertia. At static torque sensors the housing is fastened on this side.
2.2
Definition of the Pictograms on the Torque Sensor
The measuring side of the torque sensor is designated as follows:
Measuring side:
or
M
More information can be found on the data sheet, if needed.
3
Product Description
These sensors measure static and dynamic torques.
Caution: it must be differentiated between drive side and measuring side, see data sheet of the sensor:
www.burster.it
M
