BURNiT WBS AC 110-Pell 90, Installation And Operation Manual, Page: 31 / 52

31
TECHNICAL PASSPORT. INSTALLATION and OPERATION MANUAL TECHNICAL PASSPORT. INSTALLATION and OPERATION MANUAL
to open the next page.
After all settings have been confirmed,
the burner will initiate ignition sequence
according to the input parameters.
10.3. Installer’s menu (setting the
combustion parameters in the burner
controller)

CAUTION! We recommend that
this menu be used only by an
authorized installer/service shop
in order to ensure efficient and
safe operation of the equipment
2.3 / 2.2
To access the
settings adjustment
mode,
simultaneously
press the “ Enter ”
and „ F ” buttons and hold them pressed
for 4 / four / seconds.
This will display the controller hardware
and software version on the screen. Press
again button “ F ” and this will open the
initial page for the burner settings.
For access to service settings menu you
need a service menu code.
The service menu
comprises only and
u n i q u e l y
parameters with
direct impact on
boiler combustion
process, as well as
on heating
installation management (depending on
the peripherals management capacity of
the boiler digital controller unit).
10 .3.1. Cleaning setup
The burner performs
automatic cleaning
before each ignition
and shut-down.
You can use this menu to adjust the
running time of the main fan (FAN) and of
the cleaning motor (Cleaner).

Important: Once you have
browsed to the next page you
cannot return to the previous
one.
Select the desired option using the
navigation arrows. Use the „ Enter ” button
to open the next parameter. Use the „ F ”
button to open the next page of the menu.
In this submenu
you can activate or
deactivate the
automatic cleaning
of the burner in
Ignition (Start) mode or extinguished
(Stop) mode.
The checkmark in the box indicates that
the automatic cleaning system is active.
Select the desired option using the
navigation arrows. Use the „ Enter ” button
to open the next parameter. Use the „ F ”
button to open the next page of the menu.
10.3.2. General setup
In this submenu you
can set the number
of attempts ( Retries )
to ignite the burner
and the time of the
initial feed portion of pellets (
Feed
).
Select the desired option using the
navigation arrows. Use the „ Enter ” button
to open the next parameter. Use the „ F ”
button to open the next page of the menu.
10.3.3. Cycle setup
Use this submenu to
adjust the running
time of the heater
( Heater ) and the