BURNiT Pell 150, Installation And Operation Manual, Page: 22 / 36

TECHNICAL PASSPORT. INSTALLATION and OPERATION MANUAL TECHNICAL PASSPORT. INSTALLATION and OPERATION MANUAL
22
simultaneously press the “Enter” and „ F ”
buttons and hold them pressed for 4 /
four / seconds.
This will display the controller hardware
and software version on the screen. Press
again button
“Enter”
and this will open
the initial page for the burner settings.
For access to service settings menu you
need a service menu code.
The service menu
comprises only
and uniquely
parameters with
direct impact on
boiler combustion
process, as well as
on heating
installation management (depending on
the peripherals management capacity of
the boiler digital controller unit).

Fuel switching and / or change
the configuration of the heating
installation must be performed
by an authorized installer /
service. Some of these reasons
may affect the safe operation of
the facility.
9.3.1. Menu for automatic dose pellets
for maximum power
Calculation of feeding:
Power - Enter the
maximum power of the
model of boiler.

Important: Please enter the
exact power. Setting of higher
or lower power than is written
on production label of the boiler
can cause boiler damage or
physical injury.
Fuel C - Set the calorific value of used
fuel. The calorific value is marked on fuel
package.
Feed - Determine the number of cycles
for screw calibration. When entering
a larger number of cycles will get more
precise results.
Press "F" button to switch to next
submenu.
Filling of auger:
From this menu by
selecting "up arrow"
button activate
operation of main auger of the boiler
(the auger in fuel hopper). Auger began
working constantly. If the auger is empty
will take about 20 min. to be filled- well.
Capacity of Auger:
When enter this
menu, controller
automatically start to
operate 10 cycles. During these operating
cycles the auger Switch-On and Switch-
Off simulating normal operating behavior
for combustion process. Transported
by auger pellets during these cycles
should be collected (use a plastic bag)
and weighed when the last cycle is
completed. The number on right-side of
the screen shows how many cycles you
set for execution. The number on left-
side of the screen shows which cycle is
currently running.

Pending completion of all cycles
do not press the buttons display
as it will stop the process!
When the last of these set cycles has been
executed, auger will stop automatically
and controller will activate automatically
the option Weight. When option Weight
is active enter the weight of pellets. To do