TECHNICAL PASSPORT. INSTALLATION and OPERATION MANUAL
TECHNICAL PASSPORT. INSTALLATION and OPERATION MANUAL
12
Pell
25
Pell
40
Pell
70
Pell
90
Pell
150
А
250
350
350
500
500
B
390
450
550
750
800
C
250
450
450
500
500
7.1. Pellet burner connection to the fuel
hopper and pellet auger
Take the feeder chute flexible hose (from
the auger set). Using a bracket, clamp
one end of the hose onto the motor-end
outlet of the pellet auger.
- Remember – pellet auger must be
installed at 45° angle to the ground
horizontal surface.
- Fill the hopper with fuel (see table 2 for
parameters of the fuel types used)
- Plug the power cord of the pellet auger
into the indicated Schuko-type burner
socket on the left side of the burner
housing.
Diagram 5.
Mounting the pellet burner Pell to WBS
boiler
1.
WBS boiler;
4.
Auger;
2.
Pellet burner Pell;
5.
Fuel hopper.
3.
Auger flexible pipe;
7.2. Connecting the pellet burner to the
mains power supply
Such connection must be
performed by a technician /
service shop authorized for such
operations.
Caution!
ELECTRIC
SHOCK
HAZARD!
- Before opening the unit: switch
off the voltage and secure the
unit against accidental restart.
- Observe installation instructions.
It is mandatory to assure a
backup power generator of
corresponding rated power! (see
12.3)
Improper cable connections may
damage the regulator!
The device may be damaged
if struck by a lightning. Make
sure it is unplugged during the
storms.
The burner must be connected to a
220V/50Hz mains using power plug
(3 meters long, bound to the burner).
Create tight connection with the
electrical mains which complies with the
local regulations.
