12
Seat Bottom Assembly for Corbin
®
Seat Bottoms
1. Unpack the seat frame and the seat bottom from their sep a rate pack ag ing. Notice
that the hard ware for the seat bottom is installed on the seat bottom brack ets. Also,
the QR s and aluminum slider blocks are in stalled on the seat frame. To install the
seat bottom in the seat frame you must fi rst remove the hard ware from the seat
bottom brackets. This in stal la tion is easiest if per formed before in stall ing the seat
frame on the bi cy cle.
2. Slide the seat bottom brackets between the two sides of the seat frame side plates.
Install the pivot blocks from the inside by in sert ing the pivot block pin through
the hole in the seat bottom bracket and then through the slot of the seat frame side
plates. In stall the large di am e ter wash er onto the fi xing bolt and insert the bolt (from
the out side) through the slot in the seat frame side plates and seat bottom brack ets
and piv ot blocks. Install the M8 nut onto the bolt with a 13mm wrench. Tight en
the system to 150-200 in/lb.
Pivot Block Pin
Seat Bottom
Fixing Bolt
Washer
Seat Frame
Side Plates
QR Rod
Seat Frame
Seat Bottom
Bracket
Lock Washers
Pivot Block
Self-Locking
Nut
Aluminum Slider
Blocks
Corbin Seat Bottom
Nylon Slider Blocks
