English
Completing filling and dismounting
1. After the last pump stroke, leave the piston rod in
the lower position and insert it into the pump up to
the stop.
2. Close the shut-off valve on the discharge hose.
3. To prevent any liquid continue to run (siphoning
principle), fix the discharge hose above the liquid
level in the original container.
4. Unscrew the discharge hose.
5. Carefully unscrew the instrument from the container.
6. Rinse the instrument with a pH-neutral fluid.
CAUTION!
Fluid ejection off the filling container. Bodily injury
due to escaping liquid.
`
`
Wear the necessary protective clothing.
WARNING!
Some liquid will continue to run after the
discharge hose is unscrewed. Bodily injury due to
escaping liquid.
`
`
Close the shut-off valve on the discharge hose.
`
`
Raise the discharge hose and allow the liquid to
run back into the container.
Accessories
More accessories can be found at www.buerkle.de
Troubleshooting
Type
Specification
Number
Item No.
PP barrel screw joint
R 2", steel fine outer thread
1
5600-3130
PP barrel screw joint
Mauser 2“, coarse outer thread
1
5600-3170
PP barrel screw joint
TriSure, coarse outer thread
1
5600-3180
Container screw joint
Opening Ø 60 mm
1
5600-3140
PVC barrel plug
Ø 40 - 70 mm
1
5600-3150
Discharge hose with stopcock
1,20 m
1
5600-0100
SafetyBox
Incl. safety goggles and protective gloves
1
2507-9000
Drain safety stand
Total length 117 cm, Ø 35 mm
1
5618-1000
Problem
To eliminate the error
Liquid is not pumped.
Bottom valve is polluted. Clean the pump.
If there is only little residual liquid in the container, the pumping must be carried
out for a longer time.