31
pH sensor - parameter
10.7.3
Change the binary event for the automatic freeze
To change the binary event that is connected to the product, do the following procedure:
→
Make sure that the login user level is
Installer
. Refer to chpt.
→
Go to device
pH sensor MS01
function
pH sensor
tab
Parameter
.
→
Select
hold
Select data source
.
→
Select
to delete the connection.
→
If needed, select another binary event. Confirm with
Finish
.
→
Select
to take the changes into account.
The next step restarts the product.
→
Select
Finish
to restart the product.
10.8
Stop the manual freeze or the automatic freeze
→
Make sure that the login user level is
Installer
. Refer to chpt.
→
Go to device
pH sensor MS01
function
pH sensor
tab
Parameter
.
→
Select
hold
mode
Off
Validate with
.
As soon as the parameter
hold
is deactivated, the following actions are carried out:
•
The product sends the measured values on the fieldbus.
•
The product-status indicator is green.
•
The bit 2 of the pH-State byte is set to 0. The updated value of the pH-State byte is sent on the fieldbus.
Refer to chpt.
English
Type MS01
Summary of Contents for Type MS01
Page 1: ...Operating Instructions Type MS01 pH sensor cube...
Page 86: ...86 English Type MS01...
Page 87: ......
Page 88: ...www burkert com...
