Burkert FLOWave L 8098, Quick Start Manual

Page: 31 / 80

31
Installation in a pipe
Type 8098 FLOWave L
CAUTION
Risk of injury due to a heavy device.
A heavy device can fall down during transport or during installation and cause injuries.
▶
Transport, install and dismantle a heavy device with the help of another person.
▶
Use appropriate tools.
NOTICE
The device will be damaged if you use a tool to turn the blind cover or the display module.
▶
Do not use a tool to turn the blind cover or the display module.
Risk of failure or risk of accelerated ageing of electrical components.
▶
Observe the dependence between liquid temperature and ambient temperature (see Fig. 9 and
Fig. 10).
7.2 Additional documentation
→
If the device is an ATEX / IECEx device variant, then refer to the ATEX / IECEx supplement for Type
8098 FLOWave L available on the internet at country.burkert.com .
7.3 Preparing the device before installation into the pipe
The device is delivered as described in chapter 5.1.
Before installing the device into the pipe, you may:
•
change the position of the transmitter on the sensor. Refer to chapter 7.3.1.
• switch positions of the display module or of the Wi-Fi module and the blind cover. Refer to chapter 7.3.2.
7.3.1 Changing the position of the transmitter on the sensor
These instructions are valid for all the device variants.
The Type SE98 transmitter can have four positions on the Type S097 flow sensor. See Fig. 13 .
English