General information
Radiant heaters with rated powers of up to 2 kW can be switched
on and off by radio using the radio receiver 2 kW.
There is an additional possibility to switch the radiant heater to
66 % and 50 % of its rated power.
Transmission
control lamp
Programming
button
P
▲ button
(switch on)
■
STOP
button
(switch off)
▼ button
(switch on)
Back of housing
Screw
Optimal use of the radio signal
• Do not bend the antenna.
• Do not shorten or extend the antenna.
• If reception is poor, adjust the antenna.
• Install the antenna so that it is as exposed as possible.
• Antenna is not to rest on metal.
• Using a number of receivers may cause interference.
Note:
Radio systems, which operate on the same frequency,
can lead to reception interferences.
Please note that the range of the radio signal is limited
by the government and the built environment.
The radio receiver 2 kW is exclusively suitable for
radiant heaters with a rated power of max. 2 kW.
Do not connect other appliances to the device!
Follow the operating instructions of the radiant
heater.
Commissioning
Device becomes hot during operation!
Risk of burning!
• Ensure that there is sufficient ventilation for the
radio receiver 2 kW
.
• Do not use highly flammable materials in the
vicinity of the radio receiver 2 kW.
STAS3
1 = N (blue)
2 = L
3 = L (bridged with 2)
STAK3
1 = N (blue)
2 = L
I
(black)
3 = free (brown)
PE (green/yellow)
PE (green/yellow)
Feed cable
Consumer
Caution!
Do not connect L to L
I
.
→ different potentials
Caution!
Do not connect L to L
I
.
→ different potentials
Programming the transmitter
Explanation of buttons
Programming button
P
▲ button (switch on)
■
STOP
button
(switch off)
▼ button (switch on)
◄
◄
◄
◄
Warning!
Warning!
