Page 8
CLEANING
1. The use of a damp cloth rinsed in any mild, nonabrasive, liquid detergent is recommended for cleaning all
surfaces on Bunn-O-Matic equipment. Do
NOT
clean this equipment with a water jet device.
2. Check and clean each sprayhead. The sprayhead holes must always remain open.
NOTE:
Any buildup on the sprayhead may restrict water flow, and impact your coffee brewing. For consistently
great coffee, clean spratheads weekly. Upon visual inspection it may appear that light passes through all holes
in the sprayhead plate, but a thin film of residue can pass light and still impede water flow.
a. Remove sprayhead from brewer. Disassemble by removing the seal.
b. Clean the holes in the top of the sprayhead. Clean the inlet holes on the back of the sprayhead.
c. Remove any build up in the fitting where the sprayhead screws in.
d. Reassemble sprayhead and reattach. Sprayhead only needs to be hand tightened.
See page
30
of instruction manual for calibration routine to verify sprayhead flow rate matches programmed
flow rate. Machine may need to be re-calibrated due to lime build up. If machine is cleaned and build up
removed, machine must be re-calibrated to achieve desired volumes.
35058 042105
