Page 15
PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)
29877 121302
SET NEW RECIPE
Using a RECIPE CARD to load coffee names and brew
settings into the Dual
®
SH DBC with Smart Funnel
®
:
The G9-2T DBC's memory contains certain coffee
names. If the operator uses a coffee name that is not
already stored in the grinder's memory, a
RECIPE
CARD
can be obtained from the factory. The
RECIPE
CARD
would include all the information needed to set
up that particular coffee name. The information from
the
RECIPE CARD
is loaded into the grinder's memory,
then into the brewer's memory by holding the chip
area up to the equipment's sensing coil. This informa-
tion can include the coffee name,
BREW VOLUMES,
BYPASS PERCENTAGES, PULSE BREW TIMES, PRE-
INFUSION TIMES
and
DRIP-OUT TIMES
for that
particular coffee
NAME.
These can all be loaded in
seconds.
Contact Bunn-O-Matic Corporation for the avail-
ability of
RECIPE CARDS.
NOTE:
Instructions to program the brewer and grinder
are printed on the
RECIPE CARD,
along with the coffee
name that is being programmed.
Procedure to program the coffee name:
1. Remove the funnels (if present) from the left and
right funnel rails.
2. Position the
RECIPE CARD
vertically, so that the
top end of the
chip
is beneath the left side funnel
sensing coil.
3. After a short pause the display will read
CARD
CONTAINS RECIPE FOR
then will change to
(COF-
FEE NAME) SHOW QUIT SAVE
. All brewing pa-
rameters for that coffee flavor are now transferred
from the
CARD
to the brewer.
4. To show (view) this information, press and release
SHOW
. The display will scroll through all of the
brew settings for all three batch sizes. The display
will then return to
CARD CONTAINS RECIPE FOR
then will change to
(COFFEE NAME) SHOW QUIT
SAVE
.
5. If all brew settings are correct, press
SAVE
. The
display will read
(COFFEE NAME) SETUP COM-
PLETE
. All brew settings for that name are now
stored in the brewer's memory.
6. If the brewing information is not correct, or it is
desired to exit the setup before the settings are
loaded into the brewer's memory, press
QUIT
. The
display will read
(COFFEE NAME) NOT SAVED
.
The display will then return to the
MAIN SCREEN
.
POSITION CARD UNDER THE
LEFT SIDE SENSOR COIL
(COFFEE NAME)
SHOW QUIT SAVE
CARD CONTAINS
RECIPIE FOR
READY TO BREW
WATER TEMP: 200º
(COFFEE NAME)
SETUP COMPLETE
(COFFEE NAME)
NOT SAVED
SCROLLS THROUGH ALL
OF THE BREW SETTINGS
FOR THE THREE BATCH
SIZES FOR THAT COFFEE
FLAVOR
P2300
