Page 26
PROGRAMMING THE BREWER (cont.)
2. Press YES in this screen. The display should read
LEFT ->->-> RIGHT.
3. If the initial programming was done on the left side
of the brewer, press YES. The display will read ARE
YOU SURE?
4. If you are sure that the data should be transferred
from left to right, press YES. The display will then
read TRANSFER COMPLETE, and will automatically
advance to the next function screen.
5. In the LEFT ->->-> RIGHT screen, if the program-
ming was done on the right side and it is desired
to transfer from right to left, press NO. The display
will then read LEFT <-<-<- RIGHT .
6. If the initial programming was done on the right
side of the brewer, press YES. The display will read
ARE YOU SURE?
7. If the data should be transferred from right to left,
press YES. After the data is transferred, the display
will read TRANSFER COMPLETE. This will appear
for 3 seconds, then will exit to the next function
screen. Brew settings for all flavors are not the
same on both sides of the brewer, only the NO
NAME setting has been transferred.
ENABLE ADS?
This function allows the operator to choose whether
or not to display the advertising message that was en-
tered into the brewer with an AD CARD. This message
will be displayed when the brewer is not in use.
Procedure to Enable/Disable Ads:
1. Press and hold upper right hidden switch until the
display reads UNITS. Release switch. Continue to
press and release switch until the display reads
ENABLE ADS. The YES or NO will be flashing to
indicate the current selection.
2. Press and release the NO to disable this function
(no ads will be displayed on the screen), or;
3. Press and release the YES to enable this function
(ads will be displayed on screen).
4. When finished, press and release DONE to save
the new setting, exit the ENABLE ADS function and
advance to the next function screen, SET TEMP.
Another alternative is to press and release the
ON/OFF switch (either on DUAL brewers) located
on the front switch panel to exit the ENABLE ADS
function and return to the MAIN SCREEN.
°
°
°
°
SET TEMP - Range: 185˚F (85˚C) to 205˚F (96˚C)
This function allows the operator to set the brew
water temperature in the tank. It also sets the hot
water faucet dispense temperature.
Procedure to set brew temperature:
1. Press and hold upper right hidden switch until the
display reads UNITS. Release switch. Continue to
press and release switch until the display reads
SET TEMP.
ENABLE ADS ?
NO DONE YES
SET TEMP: XXX°
(-) DONE (+)
COPY SETTINGS (NO NAME COFFEE SETTINGS ONLY)
(cont.)
41342 111611
205° F (96.1° C)
