ccd_manual_e
Page 18 /36
After successful installation your screen
should look like this:
Please check the settings of the machine by
clicking on the
Options
tab and then on
ma-
chine
. You will see a picture of a CCD. If you
hover the mouse over the different functional
areas of the machine, you will notice a colour
change. Click on the areas to open the function
dialogue. If you drive over the table, you can ac-
cess the table settings for example.
In each function dialogue there is a small tooth
wheel. Click on this tooth wheel and you can either
load a different machine configuration (be careful!
Your machine only works correctly with the correct
machine configuration!) or access the advanced
features, such as correction factors.
Please compare the values in the machine
configuration of the software to the docu-
mentation provided with the machine.
Function Test in manual Operation:
Close the machine configuration and go to
the tab
Manual Operation
.
Check the function of the axis by clicking on
the arrow buttons. When you first click on
one arrow, the machine will perform a refer-
ence drive. Make sure that the control di-
odes light up when reaching the 0-position.
You can also check the function of spindle
as well as camera, dispenser or laser, if there.
Bungard Elektronik GmbH & Co. KG, Rilkestraße 1, 51570 Windeck – Germany
Tel.: +49 (0) 2292/9 28 28 - 0, Fax: +49 (0) 2292/9 28 28 - 29, E-mail: [email protected]