ccd_manual_e
Page 17 /36
In the picture on the right you can see an axis and
zero-point overview. All CCD machines are set up,
so that the motor connection box with the cables is
located on the left and the stepper motor of the Y-
axis facing the front. On the right there are the tool
slots (ATC-machines). If you stand in front of the
machine that way, then the
machine zero
is on the
front left
, the
X-axis
is on the
table level
between
motor connection box and tool slots, the
Y-axis
is
the upper
cross traverses
and the
Z-axis
with the
spindle sits on the traverse and
moves vertically
.
The only exception is the CCD/2 and the CCD/2/Eco:
this machine is set up in a way that the RS232 port
and control diodes are pointing forward. Again, the
zero point
is at the
front left
, but the
Y-axis
is in
the
table level
of the table and the
X axis
is the
cross-traverses
over the table and on this X-axis
hangs the
Z-axis
with the spindle.
RoutePro3000 installation software:
Insert the supplied CD into your computer drive and
start SetupRoutePro3000.exe. Depending on the
system, the
Windows Framework 4
and
Windows
Visual C ++ modules
must be installed on your
system. This usually happens automatically if your PC
is connected to the Internet. Possibly a reboot is
required. In the first dialog, click Register. Enter your
contact information in the next dialog. The
transmission of contact data is voluntary. An Internet
connection is not required to use the software.
The machines from 2016 are usually recognized
automatically. A driver installation is not required. If
problems arise in this regard, please contact [email protected].
Bungard Elektronik GmbH & Co. KG, Rilkestraße 1, 51570 Windeck – Germany
Tel.: +49 (0) 2292/9 28 28 - 0, Fax: +49 (0) 2292/9 28 28 - 29, E-mail: [email protected]