To hide wires you can run them underneath the CANVAS edging around the tent – merely lift this
edging, run the wiring through and glue down neatly again (you can use the canvas sleeve in the
arm to hide any additional wiring).
PLEASE NOTE
that this can affect the warranty of the tent if not to professional standards.
Maintenance
While unnecessary when not experiencing any faults, we do recommend maintenance in the older
tents, as designs are upgraded continuously. This can be done by just replacing the ropes and
re-aligning the roof.
How to replace the Ropes:
• Remove old ropes (remember to leave one arm as is as a reference when you do the new
ropes).
• Turn the turnbuckles so that they are halfway in and halfway out (about mid way).
• Roll the belt onto the barrel until about only 100mm is left.
• Snake the rope through the 4 holes in the belt, the ropes have to go through the correct
bearings in the roof.
• There are 4 bearings in the middle of the roof under the light cover, left bearing is for left far
side, second to left bearing is for is left front and the other two mirror for the right.
• Snake the rope through the arm mechanism as per the copy you left intact.
•
Tie the rope to the turnbuckle, preferably hang mans noose, otherwise just a proper knot.
•
Begin at the belt and tighten the rope through its course, the roof of the tent will lift – just keep
going until the canvas is nice and taught and tie the rope off at the belt. Repeat for each arm.
•
You can fine-tune how evenly the roof lifts/lowers by adjusting the turnbuckles. If you screw
them in, the roof will lift, if you screw them out the roof will lower – you have about 5cm to
work with.
•
If you need to lift/lower more for an even roof you need to adjust the rope at the belt area
again.
Summary of Contents for BunduTop
Page 1: ...BUNDUTOP MANUAL TM ...
