Electrical faults and how to pinpoint them
Diode
If the light inside still works, but your tent won’t lift or lower, it is most probably the diode. The
diode blows when there is a short in your wiring system. The short is caused by the wiring touching
the body.
The Limit Switches:
The Limit Switch located near the winch tells the tent when to stop lifting. The Limit Switch on the
arm tells the tent when to stop lowering.
NEVER
adjust these switches unless instructed otherwise
by a technician.
PLEASE NOTE
that it is preferable to connect your tent to the secondary battery.
PLEASE NOTE
that depending on what solar panel you have installed, you need to install a regulator
that can handle VOLTS and WATTS. A lot of smart systems can handle 28V but not the 45V that a
300W Solar Panel produces.
Location of Limit Switch near
the winch motor
Location of Limit Switch on
the arm
How do I fit the tent myself?
When installing the tent, we advise that there is no more than a 0.5m unsupported overhang.
We also advise that the roofrack/load bars should be no less than 1.27m wide.
If installing on load bars use three evenly spaced supports. The tent can be bolted on with a
minimum of 4, preferably 6 bolts and you can run wiring from the dual battery system with a Brad
Harrison plug through the vehicle or make an extension.
NO LIMIT SWITCHES WORK WHEN YOU OVERRIDE THE TENT MANUALLY. BE CAREFUL TO STOP
THE LIFTING/LOWERING IN TIME.
6
Summary of Contents for BunduTop
Page 1: ...BUNDUTOP MANUAL TM ...