Buhler Inland 1500, Operator And Parts Manual

Page: 12 / 81

bühler
1500 Bale Carrier
10
OPERATION
CAUTION
Prior to operation ensure the operator has read and
understands the safety requirements of the 1500 Bale Carrier. Ensure the pre-operation
checks have been completed prior to operation.
1. Attaching Bale Carrier To Tractor
CAUTION
Shut off tractor, engage parking brake and remove key before
working around 1500 Bale Carrier. Refer to tractor manual for tractor parking
procedures.
CAUTION
Use only the drawbar to couple the 1500 Bale Carrier to the
tractor. Ensure drawbar is capable of handling the 1500 Bale Carrier load. The tractor
must have a minimum mass of 12480 LB (5660 kg) and recommended 60 hp (45 kw).
Using the tongue jack, raise tongue to align with hitch pin, adjust clevis position
as necessary to level the carrier beams.
Position tractor and secure with locking type drawbar pin (not supplied). Use an
approved hitch pin with a mechanical retainer.
Route safety chain around the hitch clevis, around drawbar support and back
hook. Refer to tractor manual for further drawbar instructions.
Do not use intermediate support on drawbar as attaching point.
Store safety chain off the ground when not in use. If safety chain is damaged in
any way, contact your dealer for a replacement.
For serial number
08BM1500001
and later, open-center valve is a factory-
installed feature
Note:
The bale carrier is factory-configured to operate with tractors
having CLOSED-CENTER hydraulic systems (page 31).
For tractors with OPEN-CENTER or LOAD-SENSING hydraulic systems,
refer to the configuration on pages 33, 50 and 51.
2. Attaching Bale Carrier Controls To Tractor
Bale lift and push functions are controlled by the 1500 Bale Carrier valve. Two
hoses complete with black hydraulic tip covers supply pressure and tank. The
retraction hose is designated with a check valve and ensures proper flow through
the valve. Connect the return hose to the retract circuit and the extend hose to
opposite extend port.
The tilt function is controlled by the tractor’s remote valve. Two hoses complete
with red hydraulic tip covers supply extension and retraction.
Connect control handle harness to the machine harness. Connection is made at
the snubber unit by matching the appropriate socket and plug.