6
SETUP
Cables and Connections
K-BUG 6050 is supplied with two cable assemblies -- a power cable and a weaver control cable. It is also
supplied with a cable connector and a spare 3-pin connector with which the customer is to fabricate a
weld contact interface cable with the welding power source or wire feeder.
•
The power cable connects at the 3-pin panel connector
•
The weaver control cable connects at the 5-pin panel connector
•
The weld contact cable connects at the 2-pin panel connector on the side of the pendant control
•
Spare 3-pin connector for power cable
Mounting to a Torch Support
The K-BUG 6050 can be mounted onto a torch support to be used with a positioner. In the figure below,
it is shown mounted on a BUG-O FTS-1020 Torch Support. To do this, remove the Swivel Connector
(CON-1020) and Torch Holder (BUG-2708) from the torch support.
Mounting to a Carriage
The K-BUG 6050 can also be retrofitted to a carriage. Additional parts, KBUG-5089 and KBUG-5088, to
provide X-Y racking are required to achieve this.
Mounting to a Fixture
The K-BUG 6050 can be permanently mounted to any customer designed fixture or work cell.
