8
PARAMETER SETTINGS
Advanced parameters, like Puddle Build-up and Crater Fill are maintained in a hidden menu. The user
must access this Parameters Menu to view and change these settings.
1. While holding down the Start button, plug the machine into an A/C power source of appropriate
voltage, then release the start button.
2. The active parameter (i.e. “n.0”) will be displayed in the Left Dwell display. The current setting for
the active parameter ( i.e. “1.0”) will be displayed in the Right Dwell Speed display.
3. To adjust the parameter setting, turn the Left Dwell knob. Turning clockwise will increase the value;
counterclockwise will decrease the value.
4. Press and release the Start button to scroll through the parameters.
5. When finished setting (all) values, press the Stop button and unplug the machine.
Display Description
Range
Default
Unit
n.0
Puddle Build-up
0.0 - 9.9
1
sec
n.1
Crater Fill
0.0 - 9.9
1
sec
n.2
Weaving center
10 - 99
99
% (of Max speed)
n.3
Weaving Angle (Width)
0 - 90
15
n.4
Number of Min.
6 - 60
6
Pulse
n.5
Weaving Reduction Gear Ratio
20 - 200
1000
x10
n.6
Demonstration Mode
On / Off
Off
INSTALLATION AND OPERATION
1. Welding Preparation - Secure the necessary welding supplies
•
Welding Power Source and Wire Feeder
•
Shielding Gas, with pressure and flow regulators and appropriate fittings
•
Torch for gas shielded automated welding
•
Basic Weld Prep Tools
2.
Welding Process
•
Connect the control pendant to an A/C power source of appropriate voltage.
•
Mount weaver to torch support or carriage.
•
Insert torch and position torch for desired lead/lag angle to match the weld joint and so weld
torch is at desired weld starting point.
•
Set desired weave parameters - Weave Width, Weave Speed and Dwell times.
•
Verify adequate Shielding Gas Supply, if required.
•
Start Welding - Switch Weld Contact switch to AUTO and press Start button.
•
Press Stop button when welding is complete. Turn Weld Contact switch to OFF.
•
Confirm Welding End.
