Buffalo Tools MOTOR25, Instruction Manual

Page: 2 / 48

2
ITEM # MOTOR25
2.6 HP OUTBOARD MOTOR
SPECIFICATIONS:
4-Stroke Outboard Motor
2.6 HP @ 5,500 RPM
Adjustable Steering Friction
Full Throttle RPM Range: 5,250-5,750
Displacement: 72 cc
Engine type: 1 Cylinder
Bore & Stroke: 2.13" x 1.24"
Compression Ratio: 9.0:1
Fuel/Induction System: SOHV
Intake: Carburetor
Exhaust: Above Propeller
Cooling: Water / Thermostatic Control
Ignition System: CDI
Starting System: Manual recoil-start only. (A battery is not available.)
Lubrication: Splash
Gear Ratio: (27:12) 2.25:1
Gear Shift: Forward-Neutral
Shaft Length: 17"
Tilt Up Angle: 80°
Degree of Trim: 4 Positions
Steering Angle: 360°
Oil Capacity: 11.84 ounces (SAE10W30)
Fuel Capacity: 0.32 Gallon (40.5 ounces) Unleaded Gasoline
Spark Plug: BR6HS
Spark Plug Gap: 0.6
～
0.7 mm
EPA Approved
Includes: Tool Set
High Altitude Use: This outboard motor is not recommended for high altitude use above
3,000 ft. If you are using this motor above sea level, it may not function properly because
of air flow getting through the carburetor.
If a title is required for your state, contact us for a Certificate of Origin.
A remote control box (side mount type) is not available.
Transport and store vertically on an engine stand in an upright position. Keep the motor
trimmed or tilted down, especially if it’s outdoors. This will allow all of the water to drain out
of the motor’s cooling system. If it’s tilted up, some water may remain in the motor, where it
can freeze and cause a cracked block or a ruined water pump housing.