16
BD1801
MAINTEN
ANCE
REPLACING SANDING BELT
1. Remove the belt cover (2) by loosen the inner hex nut (1).
NOTE:
No need remove the inner hex nut.
2. Release belt tension by pulling down on tension handle (2). Slide old belt off the
drive and tracking wheels.
NOTE:
The sanding belt can be removed directly along the inner boundary of the
belt work table without removing the belt work table
3. Install the new belt around the wheels.
6. Install the belt cover and the two inner hex nut.
7. Start the sander and check the belt tracking before sanding operations
(See “TO PROPERLY TRACK THE SANDING BELT”).
LUBRICATION
Ball bearings are grease packed at the factory and require no further lubrication.
Use a paste wax to ensure smooth operation on all moving table parts. Do not use
any lubrication on the belt plate as this might end up on the wheels, causing them
to slip.
1
2
2
