12
MOUNTING WORKTABLE ON BELT
1. Attach the belt work table (1) to the
sanding frame using a handle (2)
and flat washer (3) as shown.
NOTE:
Ensure the locating pin (4) passes
through the table bracket and the registration
disc of the bracket is facing inwards.
BD1801
ASSEMBL
Y INSTR
UCTIONS
The use of a dust collection system with the sander is strongly recommended.
It will maintain shop cleanliness, and help prevent possible health hazards caused
by wood dust.
The sander has two dust ports. Slide the hose of your dust collector over the outlet,
and secure with a hose clamp.
NOTE:
Dryer vent hoses are not acceptable for this purpose.
DUST COLLECTION
Recommended (not included):
Search
BUCKTOOL Y-fitting 4" to 1-3/8"(O.D.) Reducer
at AMAZON.COM or https://www.bucktool.com
You can use it to attach two of your tools including your table saw, jointer, planer,
bandsaw, disc sander, belt sander, drum sander, and more.
A miter gauge (1) is supplied with your sander and can be used with the sanding
table. The miter gauge body can be adjusted from 0° to 60° right or left for angle
or miter sanding.
1. Insert the miter gauge bar (2) into one end
of the miter slot (3) in the disc table.
2. Loosen lock knob (4) and then rotate
miter gauge body to the desired angle.
3. Tighten lock knob (4).
MITER GAUGE
1
4
1
4
2
3
2
3