ASSEMBL
Y INSTR
UCTIONS
11
MOUNTING WORKTABLE ON DISC
INSTALLING TENSION HANDLE
Screw the tension handle (1) into the hole (2) of the hub and lock it.
1. Locate worktable handles (1) and washers
(2) in parts bag.
2. Place the worktable (3) onto the sander
frame, aligning the semi-circle slot (4) with
the threaded hole (5).
3. Place a washer (2) on threaded shaft of
each worktable handle (1), insert through
semi-circular slot (4), and tighten into
threaded hole (5). Repeat on other side of
table.
4. Adjust worktable to level or any angle
between 0° and 45° for sanding.
5. Mount the sanding disc cover (6) onto the
metal frame that surrounds the sanding
disc with the two Phillips Screws (7).
BD1801
To avoid injury, always keep the plug disconnected from the power source and
the switch turned OFF until the sander is completely assembled and adjusted
properly.
WARNING!
!
To avoid trapping the workpiece or fingers between the worktable and sanding
disc, the worktable edge should be positioned a maximum of 1/16 in. (1.6 mm)
from sanding disc plate.
Always sand on the downward, right side of the rotating disc.
CAUTION
!
1
1
2
5
2
4
3
The larger worktable is used with the sanding disc. It should be used to support
workpieces in all sanding operations except inside curve applications.
7
6
