Remote Enable: The 281e’s settings may be stored and retrieved with the
model 225 or the 206e preset manager. To connect or disconnect this module
from the central library function or internal bus, push the remote switch. A
lighted red LED signifies a connection.
In conjunction with the 225e, the 281e can monitor the internal MIDI bus,
responding to note on and note off messages as well as controller 64 (sustain)
as if they were pulse inputs. Sections from top to bottom (A-D) respond to
internal bus A-D respectively.
To perform this function, the device select switches (on back of unit) MUST be
set to device A. To read the device select code, depress either of the
quadrature switches for a couple of seconds. The 225p or the 206p will
display “module 281 A1” or “module 281 A2” if the switches are set for A.
Additionally, the code version number will be displayed.
Note that to load or display firmware for this module, you must use the
quadrature switches instead of the remote enable switch. There are two
computers; load each separately, using first one, then the other quadrature
switch.
For further explanation of the above features, please consult the description of
the 225e MIDI/USB Decoder.
Summary of Contents for 200e series
Page 5: ...Grey knob settings cannot be stored and will always represent the setting you see...
Page 11: ......
Page 14: ......
Page 33: ......