Buchla 200e series, User Manual

Page: 2 / 78

Introduction
Welcome to the 200e system. These notes will acquaint you with your Buchla
system, followed by individual descriptions of the various modules.
Important Safety Precautions
Do not disassemble this equipment. Refer all servicing to a qualified service
engineer. But if you insist (or if you’re definitely qualified), be sure to follow the
next advice.
When installing, removing, or exchanging a module, please be certain to turn
off the power supply. These modules are not designed to tolerate “hot
patching” – power must be turned off before plugging in or unplugging
modules.
Please note that both e-series and h-series connections and cables are keyed
to be used in one direction only! Reversing the connectors can cause
significant system damage.
We are not liable for damage or injury due to lack of common sense:
Do not use the 200 system near water; do not take it into your bath, sauna or hot tub. Take
care not to spill liquids on or into the 200.
Locate the 200 away from heat sources such as radiators, fireplaces, stoves or solar
cookers.
Exercise close supervision when using the instrument near children or when children are
using it.
The 200’s power supply is for indoor use only. Do not use a damaged or alternate supply.
Refer all servicing to qualified personnel. There are no user serviceable parts or
adjustments inside the 200h.
System/”Boat” set up
Retrieve the system from its case or carton, saving all packing materials, and
confirming the presence of a DC power adaptor with an AC cord, and
patchcords. If anything is missing, inform your source of the shortage. Place
the system on a flat surface with the connectors pointing to the rear. Unfold
and extend the support feet and unfasten any latches (if any) and prop up the
system. Connect the power adaptor to AC (110VAC or 220VAC) and the 12-
volt DC (center-positive) to the power input jack. Be sure to use the power
supply with the Amperage rating appropriate for your system. Typical systems
use power supplies rated 5.3A or higher. Systems fully loaded with 18 panels
or more use the supplies rated at 8.3A or more. Turn on the switch.
Connect Audio: If your system contains a 206e, 207e, or 227e, convenient
audio outputs may be located on the back of the case. If provided, these audio
outputs are redundant
¼ ” outputs to the Tini-Jax outputs on the front of those