8
Publication 5423-020-REV 1.0 • www.btxonline.com
The shipping carton in which your ECM 630 Electroporation
System is packed has been specifically designed to provide
maximum protection to the instrument during transportation and
normal handling conditions. Upon receipt, the carton should be
examined for any external damage resulting from shipment.
Open the carton and carefully remove the ECM 630 System
and inspect the unit for any apparent damage. Save the carton
and packing materials for future transportation and shipping
requirements.
Packing Data
Check the packing slip to ensure that all items ordered and listed
are included in the shipment. Inform BTX immediately if any parts
are missing or damaged.
Power Source
As received, the instrument is ready for use with either 100–240 V
AC, 50/60 HZ.
The power requirements are 350 watts. In the USA, the power
cord has a standard three prong plug.
Installation
Once you have determined that the components of the system
have not sustained any obvious damage in shipment, proceed
with the installation.
Remove the insulating tab from the battery at the base of the unit.
Place the generator in a location that is a dry, level, sturdy surface
free from extremes in ambient temperature, dust or chemical
exposures. Allow the device to equilibrate to room temperature.
Unpack the safety dome, cuvette rack and disposable cuvette
chambers. Connect the safety dome, specialty electrode, or the
HT plate handler into the connectors at the bottom right-hand
side of the front panel.
Connect the mains/power cord to into the back panel at the
bottom left.
Power up the system by pushing the rocker switch located on the
back panel at the bottom left. The display will flash the BTX logo.
Once the software initializes, the Main Menu screen will appear.
You are now ready to begin your work.
Main Power Switch
Fuse Holder
Universal Power Input
USB Serial Input
Footswitch Input
(switch sold
separately)
High Voltage Output
Touchscreen Display
Unpacking the System
Remove Battery Insulating Tab.
