btsr SMART MATRIX MTC, Operating Manual

Page: 28 / 82

Sensor Configuration and Numbering
SMART MATRIX MTC 2 - 10
•
Point and select MACHINE SIDES .
•
Set the number of machine sides ( A corresponds to 1,
AB to 2, ABC to 3 and ABCD to 4 ).
•
Point and select SECTIONS PER SIDE . Set the
number of sections per side.
•
Point and select DEV. PER SECTION ( e.g. 06 )(*).
To confirm the set values.
SAVE to save the settings and startup the numbering
procedure.
•
The example shown indicates that the numbering
(identification) procedure of the 6 configured sensors is
going to begin.
•
The display of SM-DIN Boards will show
•
The green led will flash on all sensors
•
Shim the touch light of the sensor corresponding to
SIDE: A , SECT.: 01 , DEVICE: 01 .
The sensor’s led changes from flashing green to red.
•
On SMART MATRIX display, the DEVICE, SECTION
and SIDE fields will automatically increase to select one-
by-one the sensors to be numbered
•
Shim the touch light of the relevant sensor and continue
with the numbering of all sensors.
At the end of the numbering operation, the configuration
menu will re-appear.
To return to SETUP menu
(*)The totale number of configured devices ( MACHINE SIDES x SECTIONS PER SIDE x DEV. PER
SECTION ) must match the total number of devices previously set on BOARDS CONFIGURATION screen.
Otherwise a “ DEVICE NUMBER MISMATCH ” error message will appear”