btsr IS3W/TTS, Operating Manual

Page: 6 / 81

Introduction
- I.2 - SMART 200 TTS
Within the Appendix A “Quick Reference” the push-buttons of SMART control
panel are shown as follows:
Meaning of the Capital/Small Letters on Display
Within the functions that provide two programmable alternative options, i.e.:
Normally Open or Normally Closed Contact
Enabled/Disabled Condition
Pulse/Continuous Signalling, etc.
The letters shown on display as capital letters indicate the currently active choice,
while the small letters refer to the possible alternative choice.
Example:
Item Function Current Programming
TT-tb TT = twisting profile control
tt-TB
Sensor working mode: Twisting
Profile
(TT) or Balloon (TB)
TB = yarn balloon control
TP-imS TPS = twisting (balloon) per second
TP-iMs TPM = twisting (balloon) per meter
TP-Ims
Measurement unit of Twisting
(Balloon) : Second (S) , Meter (M) ,
Inch (I)
TPI = twisting (balloon) per inch
MO-ctr MO = Monitor
mo-CTR
Monitor (MO) or Control (CTR)
mode
CTR = Control
RES-mA MA = sensor reset-Auto
RES-Ma
Sensor reset mode: Automatic
(mA) or Manual (Ma)
Ma = sensor reset-Manual
LK-ulk LK = “touch light” disabled
lk-UKL
Enabling (ULK) or disabling (LK)
the “touch light” button.
ULK = “touch light” enable
ST-NCo
NCo = normally closed
ST-NcO
Stop Output programmable as
Normally Closed
(NC) or
Normally Open (NO) contact
NcO = normally open
ST-Cp Cp = continuous signal
ST-cP
STOP output programmable as
continuous signal
(CONT) , pulse
signal 2 seconds (P2s) or pulse
signal 10 seconds (P10s)
CP = pulse signal
Alternative items:
Within the description of configuration/programming procedures the alternative
screen shots are shown with this bracket symbol.