btsr IS3W/TTS, Operating Manual

Page: 44 / 81

Operation
- 3.32 - SMART 200 TTS
COM TEST - Testing the Efficiency Rate over the Communications Line between
the SMART 200 TTS Terminal and Sensors
SETUP CONFIG TEST COM
This function allows you to check the perfect operation of the communications line
between the SMART 200 TTS Terminal and connected Sensors.
It is advisable to run this check during the first testing phase (immediately after
installation) and each time random problems occur in the system operation, which
may have been caused by inefficient communications between the Sensor and the
Terminal (for example: Defects along the yarn which have not been signalled by
the sensors).
Press until the TEST CONFIG menu option is displayed.
Press to have access to the Test function.
Press to select the Communications Test.
This screen indicates that the Communications Test is going to start.
Press to begin the test.
From this moment on, the system communicates repeatedly with all connected
sensors. The running test status is signalled by the flashing red LED inside ENTER
button. If there are no communications errors detected, the display shows the
message TEST CO 000/000. If communications errors are detected, the display
shows the message TEST CO XXX/YYY, where the XXX indicates the total
number of failed attempts and YYY indicates the total number of sensors where
some problems occurred.
Press once to leave this function, or press it twice to return to the Main Menu.
A
14