Fault diagnosis
2016-03-10 / DIS 184_58300000140186_ara_en_k
Copyright by BSH Hausgeräte GmbH
Page 57 of 181
Fault
Possible cause
Troubleshooting
Gap between panel and door varies
(in appliances installed next to each
other)
Not a fault. Production-related tolerances.
?
Repair set (Z clamps) [ 00633544]
-
The larger exhaust gap can be reduced by 0.6 mm by installing a repair set.
-
The exhaust gap in fully automatic coffee machines
cannot
be reduced.
-
The exhaust gap
cannot
be reduced in appliances that already have a Z clamp
installed (to correct the parallelism of the exhaust gap).
► Remove the front glass (see instruction manual).
► Insert the Z clamps.
► Put back the front glass (see instruction manual).
Connecting sleeve of the cooking
compartment seal is becoming frayed
Connecting sleeve not protected against
fraying.
-
The fibres of the new connecting sleeve are now pushed inwards at the ends.
► Replace the seal if defective.
► Advise customer:
This seal is highly heat-resistant and consists of a shaping wire that is covered by a
braided hose.
The join in this hose is covered by a further braided sleeve of the same material.
The seal and its connecting sleeve should be cleaned as specified in the instruction
manual, i.e. using only water with a little detergent.
You should not use any harsh or abrasive cloths, sponges or cleaning agents.