BSH HBG633BS1, Repair Instructions

Page: 59 / 101

Test
2017-03-23 / DIS 184_58300000197442_ARA_EN_A Copyright by BSH Hausgeräte GmbH Page 59 of 101
5.9 Checking condensation
5.9.1 60 cm appliances
Required tools:
?
Baking tray (appliance accessory)
?
Universal pan (appliance accessory)
Prerequisite:
• Built-in vapour valve motor (Page 101) has been checked.
• Built-in vapour valve (Page 100) has been checked.
• Function of vapour system (Page 76) has been checked.
1. Slide universal pan in at level 1.
2. Fill the universal pan with 0.5 l of water.
3. Slide the baking tray in at level 3.
4. Fill the baking tray with 0.5 l of water.
5. Set the 4D hot air heating mode.
6. Set the temperature at 250 °C.
7. Set the duration at 30 minutes.
8.
The door must not be opened during operation.
Start the appliance.
Result:
The appliance is OK if no condensation escapes while the door is closed.
Appliance without steaming function and without microwave:
After condensation-intensive operation, water may run out of the door and onto the
furniture when the door is opened.
Not a fault. Current state of technology.
Any leaking condensation should be mopped up. Alternatively, condensation strip
[ 11003837] can be retrofitted along with the panel holder [ 11003838] and three
self-tapping screws [ 00611413] .
Appliance with steaming function:
When the door is opened, water escapes from the door and runs onto the
condensation strip, and from there into the bottom section of the housing to
evaporate.
Not a fault. Current state of technology.
Appliance with microwave:
After condensation-intensive operation, water may run out of the door and onto the
furniture when the door is opened.
Not a fault. Current state of technology.
Any leaking condensation should be mopped up.
5.9.2 45 cm appliances
Required tools:
?
Universal pan (appliance accessory)
Prerequisite:
• Built-in vapour valve motor (Page 101) has been checked.
• Built-in vapour valve (Page 100) has been checked.
• Function of vapour system (Page 76) has been checked.
1. Slide the universal pan in at level 2.
2. Fill the universal pan with 0.5 l of water.
3. Set the temperature at 250 °C.
4. Set the duration at 30 minutes.
5.
The door must not be opened during operation.
Start the appliance.
Result:
The appliance is OK if no condensation escapes while the door is closed.
Appliance without steaming function and without microwave:
After condensation-intensive operation, water may run out of the door and onto the
furniture when the door is opened.
Not a fault. Current state of technology.