Bandit
Copyright 5/09
PAGE
MODELS 2000XP / 2100SP
BOLT TORQUE CHART
(THESE TORQUES ARE BASED ON DRY, CLEAN THREADS)
DESCRIPTION
BOLT SIZE
TORQUE (FT.-LBS.) TORQUE (Nm)
Grinder Bearing Bolts
/”- NC
95
9
Grinder Bearing Set Screws
57
77
Engine Hold Downs
/”- NC
95
9
Engine Sheave Bushing - SH
/”-0 NC
9
Engine Sheave Bushing - SDS
/”-0 NC
9
Jackshaft Sheave Bushing - SK
5/16”-18 NC
15
20
Jackshaft Sheave Bushing - SF
3/8”-16NC
30
41
Jackshaft Sprocket Bushing
23
31
Cutter Wheel Sprocket Bushing
23
31
Cutter Wheel Bushing
5/6”-8 NC
5
0
Cutter Wheel Pocket Bolts - Green Teeth
5/8”-18 NF
180 - 240
244 - 325
Cutter Wheel Tooth Nut - Green Teeth
0 - 8
7 - 8
Cutter Wheel Pocket Bolts - Pin Style Teeth
5/8”-18 NF
150
203
Steering Motor Coupler Bolts
/”- NC
60
8
Lug Nuts
/”-0 NF
90 - 0
- 6
Before tightening bolts be sure you have the correct size bolt for the correct amount of torque.
Use only factory approved bolts and hardware.
MAINTENANCE SECTION
PAINT CARE
To help keep up the appearance of your Bandit Equipment and reduce the possibility of surface
rust follow these steps:
) The machine should be washed on a regular basis with a non-abrasive mild detergent and
then rinsed thoroughly. Do not pressure wash sensitive areas like: decals, gauges,
electronic devices, autofeed control, etc.
2) If a stone chip, paint scratch, or paint crack occurs - it should be repaired immediately.
Simply sand the edges of the damaged paint area, mask off the surrounding area and apply
primer and paint to the dry, clean, and warm surface. This will help keep the damaged area
from spreading or getting worse.
3) If you are unable to sand and mask the area, there are containers of primer and paint
available. A small brush can be used to touch up the area.
4) Also, primer and most colors of paint are available in aerosol spray cans to simply spray
over the effected area after it is cleaned, dry, and warmed. This method is not as reliable as
the process in step #.
It is also reported that some equipment owners polish their machine at least yearly, and keep good
mud flaps on their towing trucks.