Bandit
Copyright 5/09
PAGE 5
MODELS 2000XP / 2100SP
CONTROLS
MODEL 2100SP CONTROL OPERATING PROCEDURES
1. Swing Speed Control:
The swing speed controls the rate the cutter wheel passes through the stump. To increase or decrease the
swing speed, the control knob will have to be turned clockwise or counter-clockwise depending on if the machine
has manual hydraulic controls or electric hydraulic controls and when it was built.
2. Steer Right / Left:
To steer the machine to the right, push the handle or switch, away from the operator. To steer the machine to
the left, pull the handle or switch, towards the operator. The steering is stationary when the handle or switch is
in the center location.
3. Travel Forward / Reverse:
To move the machine forward, push the handle or switch away from the operator. To reverse the machine, pull the
handle or switch towards the operator. The machine is stationary when the handle or switch is in the center location.
4. Cutter Down / Up:
To lower the cutter wheel, push the handle or switch away from the operator. To lift the cutter wheel, pull the handle or
switch towards the operator. The cutter wheel lift is stationary when the handle or switch is in the center location.
5. Tongue Out / In (optional):
To extend the tongue out, push the handle or switch away from the operator. To retract the tongue in, pull the handle
or switch towards the operator. The tongue is stationary when the handle or switch is in the center location.
6. Boom Travel Left / Right:
To swing the cutter wheel to the left, push the handle or switch, away from the operator. To swing the cutter
wheel to the right, pull the handle or switch, towards the operator. The swing is stationary when the handle or
switch is in the center location.
7. Drive High / Low:
High and low are used to move and position the machine. Low is used to position the machine near the stump
or while cutting the stump. High is used to move the machine to the working area. Handle must be down to use
the high speed travel.
8. Hour Meter, Tachometer, Super Sweep Tachometer:
Depending on options, may display the engine hours, the engine rpm’s and hours, or the engine rpm’s, hours,
and control the super sweep valve.
9. Travel Speed Control:
Controls the rate the machine approaches the stump. To increase or decrease the travel speed, the control
knob will have to be turned clockwise or counter-clockwise depending on if the machine has manual hydraulic
controls or electric hydraulic controls and when it was built.
10. Tether Plug Jack:
Plug the tether control cord in here to control the machine if the batteries in your remote control run out of power.
11. Key Switch (varies with engines):
Start the engine here. May be located on the engine instead of the control box.
12. Remote / Local:
To use the controls on the remote or the tether control, push or pull the switch to the remote position. To use
the controls on the machine, push or pull the switch to the local position.
13. Engine Throttle (varies with engines):
To increase the rpm, push the switch away from the operator. To decrease the rpm, pull the switch towards
the operator. If throttle is located on the engine, refer to the engine manufacturer’s manual.