©2011,2005 BRUNO INDEPENDENT LIVING AIDS, INC.®
SRE-2750 INSTALL 05-17-2011
18
4. Fold down the footrest.
5.
LOOSEN BUT DO NOT REMOVE*
the (3) M10
gold
zinc
hex head cap screws (17 mm wrench). See left.
6. Place a level on the footrest.
7. Pivot the seat post right or left as necessary to level
the footrest.
8. While holding the seat post steady, tighten the (3) M10
gold
/zinc screws to a torque of 80 ft. lbs.
Right-hand installations
1. Fold down the footrest.
2. Remove the
M8
hex head screw (see left). This is the
safety lock screw
3.
LOOSEN BUT DO NOT REMOVE*
the (3) M10
gold
zinc
hex head cap screws (17 mm wrench). See above left.
4. Pivot the seat post assembly to the opposite side of the
carriage.
5. Re-insert and tighten the M8 zinc hex head cap (safety
lock) screw.
6. Place a level on the footrest.
7.
Pivot the seat post right or left as necessary to level
the footrest.
8. While holding the seat post steady, tighten the (3) M10
gold
/zinc screws to a torque of 80 ft. lbs.
The screw will penetrate a hole in the angle retainer lock
plate mounted behind the carriage wall.
*
If screws are accidentally
removed, be sure to
re-install the safety
lockwashers
(installed at the
factory) when you
re-install the screws.
X
X
X
(3) M10
gold
zinc hex head cap
screws
M8 zinc hex head cap
screw
Refer to torque specifications on page 5.
INSTALLATION
