BRULA NEO service instructions
Dated 03/18
Page
4 of
52
1 General information
You have decided in favour of a BRULA fireplace insert accessory - thank you
for your confidence in our company.
These installation and service instructions provide details on the installation and
start-up of the combustion control system.
Details on operation of the combustion control can be found in the
BRULA NEO
operating manual
Important information is printed in bold.
Important information and safety
instructions are printed in red and bold - always comply with these points.
Before using the appliance, please read the entire operating manual.
The combustion control system is pre-set to the nominal thermal output of the
delivered fireplace. Information concerning the nominal heat output and the
wood feed quantity can be found in the operating manual of the fireplace.
1.1. Information on installation
Please consult your district master chimney sweep before assembling and
installing your fireplace. He will advise you on building regulations, will check
the suitability of your chimney, will commission your fireplace and will issue the
operating licence for your fireplace.
When installing and operating the fireplace insert and connecting it to the
chimney, make sure that you comply with the national and European standards,
the country-specific and local directives and regulations as well as the fire
regulations for your state (in Germany only) and the Technical Rules of the
Stove and Hot Air Heating System Trade (TROL).
All work on the electrical installation may only be performed by an authorised
specialist company. All equipment must be switched off at the main switch
before performing work on it.
