BRP Sea-Doo GTX 170 2022, Operator'S Manual, Page: 126 / 204

124
E En ng giin ne e C Co oo olla an ntt R Re ep plla acce em me en ntt
Coolant replacement should be per-
formed by an authorized Sea-Doo
dealer.
IIg gn niittiio on n C Co oiillss
IIg gn niittiio on n C Co oiill A Acccce essss
1. Remove tether cord from the en-
gine cut-off switch.
2. Remove seat(s).
3. Remove engine service cover by
removing the retaining screws.
IIg gn niittiio on n C Co oiill R Re em mo ovva all
1. Disconnect ignition coil connector.
N NO OT TIIC CE E
D Do o n no ott p prryy o on n iig gn niittiio on n cco oiill u ussiin ng g
a an nyy tto oo oll..
2. Remove ignition coil retaining
screw.
3. Remove ignition coil from spark
plug by rotating coil side to side as
you pull up.
IIg gn niittiio on n C Co oiill IIn nsstta alllla attiio on n
1. Install ignition coil on spark plug.
2. Align the retaining screw hole of
the ignition coil with the threaded
hole on the valve cover.
3. Push the ignition coil all the way
down until it rests on the valve
cover.
4. Install and tighten retaining screw.
T Tiig gh htte en niin ng g T To orrq qu ue e
Ignition coil
retaining
screw
9 ± 1 Nm
(80 ± 9 lbf-in)
5. Reconnect ignition coil connector.
6. Install the engine service cover
and tighten the screws to
specification.
T Tiig gh htte en niin ng g T To orrq qu ue e
Engine
service
cover
screws
2.75 ± 0.25 Nm
(24 ± 2 lbf-in)
7. Install the seats.
S Sp pa arrkk P Pllu ug gss
S Sp pa arrkk P Pllu ug g R Re em mo ovva all
1. Remove ignition coils. Refer to
Ignition Coil Removal .
2. Unscrew spark plug completely us-
ing a spark plug socket.
1. Approved socket
2. Improper socket
3. Clean the spark plug and cylinder
head with compressed air.
4. Use the ignition coil to take spark
plug out of its hole.
MAINTENANCE PROCEDURES