BRP Sea-Doo GTX 170 2022, Operator'S Manual, Page: 111 / 204

109
S Sp pe ee ed d L Liim miitte err M Mo od de e
Speed limiter mode is a function of
iTC (intelligent Throttle Control) sys-
tem that allows the operator to set the
desired maximum watercraft speed.
This is useful when cruising for long
distances, operating in limited speed
zones, or towing a tuber, skier or wake
boarder.
The operator must keep the throttle
depressed to maintain forward speed.
Once the maximum speed is set, the
operator
can vary the watercraft
speed from idle speed up to the set
speed using the throttle lever. The set
speed will not be exceeded even if the
throttle lever is fully depressed.
As you proceed under a constant
speed setting, keep your attention lev-
el up to maintain good situational
awareness.
Slowing down is a matter of releasing
the throttle lever further than the set
point, or by pulling the iBR lever in.
If the iBR lever is pulled in for braking,
Speed Limiter mode is overridden but
n
no ott d de ea accttiivva atte ed d.
Once the iBR lever is released and
the throttle is pulled in to engage for-
ward thrust, the speed limiter function
will reengage to limit the watercraft
speed as it was set before.
P Prre erre eq qu uiissiitte e ffo orr S Sp pe ee ed d L Liim miitte err
M Mo od de e A Accttiivva attiio on n
Speed limiter MODE can be activated
when the watercraft is going at more
then 15 km/h (9 MPH).
N NO OT TE E::
Speed limiter mode is not available if
slow speed mode is engaged.
A Accttiivva attiin ng g S Sp pe ee ed d L Liim miitte err M Mo od de e
1. Maintain a constant speed.
2. Press the Speed Control button on
the left keypad.
1. Speed Control button
You will hear a beep indicating that
you are now in speed limiter mode,
and the speed control MODE indicator
will be lit.
T TY YP PIIC CA AL L
N NO OT TE E::
Activating speed limiter mode of oper-
ation only limits the maximum speed
available when depressing the throttle
lever. The throttle lever must be held
in to maintain forward speed. Water-
craft speed can be varied from idle up
to the set cruise speed using the throt-
tle lever once the speed limiter func-
tion is activated. Watercraft speed
may vary depending on water condi-
tions during use.
D De ea accttiivva attiin ng g S Sp pe ee ed d L Liim miitte err M Mo od de e
To deactivate speed limiter mode:
1. Release the throttle lever.
2. Press and hold the SPEED CTRL
button or press MODE button.
Deactivation of speed limiter mode is
indicated by:
OPERATING MODES