62
OUTBOARD RIGGING
EVINRUDE E-TEC 60° V MODELS 115–200 HP
Route the harness under the front of the
EMM
and
around the port side of the powerhead. Secure
with tie straps.
Use an
I-Command
Ignition and Trim Harness to
connect the outboard to the key switch and trim/tilt
control. Seal unused
SystemCheck
connector
with 6-Pin Connector Seal, P/N 586076.
If connecting to an existing
Deutsch
-style
I-Com-
mand
network, connect the purple wires between
the
I-Command
Ignition and Trim Harness and the
I-Command
Engine Interface Cable. This connec-
tion supplies power to the network when the key
switch is on. Newer, quick connect-style networks
do not use this connection.
Route the harnesses around the starboard side of
the powerhead along the same path as the battery
cables.
Secure all cables with tie-straps.
For an
I-Command
oil level display, an accessory
CANbus oil level sender must be installed in the
oil tank. Connect the sender to the
I-Command
network. Refer to the
I-Command
Digital Net-
work Guide
, P/N 355008.
1.
Harness routing
2.
Tie straps
005268
1.
I-Command
Ignition connector
2.
Trim/Tilt connector
3.
SystemCheck
connector (with seal)
005266
1
2
1
2
3
1
1.
Network power supply connector
005269
1.
Anchor points
005270
1
1
