35
OUTBOARD INSTALLATION
TRANSOM MEASURING AND DRILLING
2
Before drilling any mounting holes:
•
Make sure the hole locations provide enough
clearance for mounting bolts and washers.
•
Check the inside area of the transom for
obstructions.
•
Check transom height(s) at centerlines.
Drill four ½ in. (13 mm) mounting holes in the
appropriate locations.
IMPORTANT:
Be sure to drill the required holes
perpendicular to transom surface.
40–65 HP, M
ANUAL
T
ILT
MODELS
25–30 HP, M
ANUAL
T
ILT
M
ODELS
15 HP, P
OWER
T
ILT
M
ODELS
Center the outboard on the transom (or mounting
bracket) and tighten clamp screws by hand.
Use each stern bracket’s mounting holes as a
guide to drill holes through the transom.
•
40–65 HP models require four 5/16 in. (8 mm)
holes
•
25–30 HP models require two 5/16 in. (8 mm)
holes
•
15 HP models require four 5/16 in. (8 mm)
holes.
40 – 65 HP Models
002215
25 – 30 HP Models
007998
15 HP Models
007999
1
1
1
1
1
1
