61
OUTBOARD RIGGING
EVINRUDE E-TEC 60° V MODELS 115–200 HP
3
Connect outboard main wire harness to boat wire
harness. Secure connectors in brackets.
Route oil tank sending unit harness around the
front to the port side. Secure all cables with tie
straps.
Secure all cables with tie-straps.
BE SURE all harnesses and wires
are not pinched, cannot contact flywheel, and
do not interfere with moving throttle or shift
linkages.
Replace flywheel/harness connector cover.
I-Command
Network Connections
If the outboard will be used with
I-Command
, or
other
NMEA 2000
compliant CANbus instruments,
use the following connections to supply informa-
tion to the network:
If using an
Evinrude ICON
control system, the
I-
Command
Engine Interface Cable, Power Supply
Kit, and Ignition and Trim Harness are not
required. Connect the
I-Command
network
directly to the
ICON
gateway module. Refer to
Evinrude ICON / I-Command Harness Connec-
tions
on p. 14.
If using a mechanical control system, connect the
I-Command
Engine Interface Cable to the
EMM
CANbus connector.
1.
Harness connections
004951
1.
Low oil sender connection
2.
Tie straps
004952
1.
Anchor points
005270
1
1
2
1
1.
EMM
CANbus connector
005267
NOTICE
1
