57
OUTBOARD RIGGING
EVINRUDE E-TEC 90° V MODELS 200–300 HP
3
current, resulting in erratic operation of the
remote control system.
For more information, refer to the
Evinrude ICON
Remote Control System Installation Guide
,
P/N 764952.
Water Pressure Gauge
To display engine water pressure, install a water
pressure hose fitting in the cylinder block as
shown.
Use
Pipe Sealant with Teflon
on the threads of the
hose fitting. Refer to installation instructions sup-
plied with gauge.
Route the water pressure hose around the star-
board side of the powerhead along the same path
as the battery cables.
For an
I-Command
water pressure display, sev-
eral water pressure sensor kits are available.
Refer to the
Evinrude/Johnson Genuine Parts
and Accessories
catalog.
To send water pressure data to the
EMM
, along
with an
I-Command
display, install a water pres-
sure transducer kit.
Water pressure readings in excess of 40 psi (275
kpa) are possible for 90° V6 models at boat
speeds in excess of 50 mph (80 kph/43 kts).
Use 50 psi Water Pressure Transducer Kit,
P/N 5008640.
Connect the transducer lead to the engine wiring
harness connector.
1.
Water pressure hose fitting
005035
1
1.
Water pressure transducer
008131
1.
Water pressure transducer lead
2.
Engine harness connector
004120
1
1
2
