FLUIDS
rmo2010-001-062_a
TYPICAL
1. Oil dipstick
4. Wipe off the dipstick.
5. Reinsert and
completely screw in
the dipstick
to assure an accurate reading.
6. Unscrew and remove dipstick again.
7. Check oil level on dipstick. It should be near or
equal to the upper mark.
rmr2008-011-102_a
1. Upper mark (F)
2. Lower mark (add)
3. Operating range
If oil level is at or near upper mark:
– Do not add oil.
– Properly insert and tighten dipstick.
– Install the LH middle side panel.
If oil level adjustment is required:
– Adjust oil level until it is in the operating range,
close to the upper mark.
Do not overfill.
– Properly insert and tighten dipstick.
– Install the LH middle side panel.
NOTE:
At the lower mark, 500 ml (.5 qt (U.S. liq.))
of oil is required to adjust level to upper mark (F).
Vehicle Parts Reinstallation
1. Wipe off any spilled oil.
2. Install LH middle panel.
2.1 Insert the middle side panel tabs into the
bottom side panel slots.
rmo2008-001-034_a
1. Bottom side panel slot
2. Middle side panel tab
2.2 Press down panel top edge with both
hands and push in
2.3 While pressing, ensure that lower tabs re-
main in slots.
rmo2008-001-033_b
1. Press down top edge
2. Push top edge under top side panel edge
2.4 Secure panel by pushing and turning each
clip clockwise (1/4 turn).
rmo2008-001-035_a
NOTE:
Clip is properly fixed when a small amount
of force is required while turning clip to its maxi-
mum rotation. Clip is not properly fixed when it is
loose while turning.
28 / 39
2014-2
PREDELIVERY
