BRP BOMBARDIER DS250 2006, Shop Manual, Page: 27 / 284

Section 01 MAINTENANCE
Subsection 03 (STORAGE PROCEDURES)
CVT TRANSMISSION
Remove drive belt from pulleys.
Inspect and clean pulleys then spray XP-S Lube
(P/N 293 600 016) on pulley faces.
Do not reinstall drive belt. Close CVT cover.
VEHICLE
Cleaning
To facilitate the inspection and ensure adequate
lubrication of components, it is recommended to
clean the entire vehicle.
Wash and dry the vehicle.
CAUTION: Never use a high pressure washer
to clean the vehicle. USE LOW PRESSURE ON-
LY (like a garden hose). The high pressure can
cause electrical or mechanical damages.
Remove any dirt or rust.
To clean the vinyl or plastic parts, use only flannel
clothes with BRP Vinyl & Plastic Cleaner (P/N 413
711 200).
CAUTION: It is necessary to use flannel cloths
on plastic parts to avoid damaging surfaces.
Never clean plastic parts with strong detergent,
degreasing agent, paint thinner, acetone, prod-
ucts containing chlorine, etc.
To clean the entire vehicle, including metallic parts
use BRP Cleaner (P/N 293 110 001).
Inspect the vehicle and repair any damage. Touch
up all metal spots where paint has been scratched
off. Spray all metal parts with XP-S Lube (P/N 293
600 016).
Rags Installation
Using cleans rags, block the following locations:
CVT inlet and outlet hoses, air filter box inlet and
muffler. The rags will prevent the intrusion of
small animals, leaves or other debris.
CAUTION: Do not forget, these rags must be
removed during preseason preparation before
starting the vehicle.
vmr2006-063-001_a
CVT AIR INLET HOSE — FRONT OF VEHICLE
1. CVT air inlet hose
2. Radiator cap
3. Front fender
vmr2006-063-002_a
CVT AIR OUTLET HOSE — RH REAR SIDE OF VEHICLE
1. CVT air outlet hose
2. Protective box for end of hose
vmr2006-063-003_a
AIR FILTER BOX INLET — UNDER SEAT
1. Air inlet
2. Air filter box cover
8
vmr2006-063