BW1250
Sep. 22, 2006
Browan
Page 58 of 68
You can configure your SNMP agent to send
SNMP
Traps
(and/or inform notifications) under the
defined host (SNMP manager) and community name (optional).
Figure 66 – SNMP Trap table settings
Click
Add
to add a new SNMP manager or
Delete
to delete a specific SNMP manager. Clicking
Add
:
Figure 67 – Add SNMP Trap
Host IP
– enter SNMP manager IP address [dots and digits].
Host Port
– enter the port number the trap messages should be send through [number].
Trap Type
– select trap message type [v1/v2/inform].
Community
– specify the community name at a SNMP trap message. This community will be used in
trap messages to authenticate the SNMP manager. If not defined, the default trap community name
will be used (specified in the SNMP table) [1-32 all ASCII printable characters, no spaces].
Save
– save all current settings
Cancel
– restore the last settings
System | Telnet
Use
System | Telnet
menu to manage the telnet/SSH service of your BW1250.
Figure 68 – System Configuration settings
Telnet Service
– Enable or disable telnet service of BW1250
SSH Service
– Enable or disable SSH service of BW1250.
The default of these two services are all
Enabled
. The current IETF SSH (SSHv2) is supported for
security of accessing BW1250 via telnet/CLISH.
System | Configuration
Use the
System | Configuration
menu to configure such system utilities:
